Paper Art Gerbera
Materials preparation: tissue paper, double-sided tape, white latex, crepe paper, wire, scissors, gerbera petal template.
Production tutorial:
1. First cut a long strip with a length of 20cm and a width of 5cm.
2. Stretch the cut strips.
3. Apply white glue to the right side.
4. Apply the white glue evenly with a brush.
5. Close and overlap the two sides of the strip.
6. Fold into small parts and cut out petals according to the template.
7. Scrape the cut petals with your fingertips. A flower needs about 30 petals.
8. Prepare a green strip with a length of 20cm and a width of 2cm. After folding, cut it at a distance of 3-5mm without cutting it.
9. Knead the cut flower heart finely by hand.
10. Apply white glue on the bottom and paste it on the iron wire (make a small tick on the top of the iron wire to prevent the flowers from falling off).
11. Cut out the stamens.
12. The large size is 3×15cm, the medium size is 2.5×15cm, and the small size is 2×15cm.
13. Scrape the top of the stamen slightly outward to make a point of curvature.
14. Paste and assemble on the flower center in order from small to large.
15. Paste the petals and paste them on the edge, about 15 pieces per layer.
16. The second layer is misplaced and pasted to fill the gap.
17. Cut a small strip of calyx and paste the calyx.
18. Use paper towels to thicken the stems.
19. Cut a thin strip of crepe paper and wrap it around the flower stem twice.
20.Effect after completion.
Comments
Post a Comment